mutiples access pseudowire directly under a bridge domain
Does any body could help me to understand the difference between using a using a vfi instead of having just multiples access pseudowires under same bridge domain, is there any difference.
I am reaaly intrigue of how it works when i have multiple neighbor configured under same bridge-domain. I tough that if we need to connect to multiple neighbors neighbors from a bridge-domain we always have to use vfi.
This document summarises various health checks that can be done on a Cisco VIM pod.
Cloud sanity checks the health status of network, storage and various openstack infrastructure components like mariadb, rabbitmq etc....
The following pre-requisites are necessary for the migration from RSP440 to RSP880-LT to be successful.
Make sure that you have console access to the router.
Verify that the system is running a minimum o...
BGP flowspec in a nutshell is a feature that will allow you to receive IPv4/IPv6 traffic flow specification (source X, destination Y, protocol UDP, source port A .. etc) and actions that need to be taken on that traffic (...
While gNMI is fairly new, it's becoming more and more powerful. Its abilities to simplify network management by the use of protocol buffer files and standard definitions are enabling our customers to integrate a lot ...
Today we are releasing to the public a tool to help find differences in command outputs in two points in time (IE pre and post MW).
The issues we are addressing is what commands to gather and how to successfully parse the data when timestamps, upti...