cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
2892
Views
0
Helpful
9
Replies

Power on new RSP880 at ASR9K

Moh Ka
Level 1
Level 1

Hi Expertise,

i will power on new RSP880 at ASR9K, So what's default/current ios release on that RSP

9 Replies 9

Eddie Chami
Cisco Employee
Cisco Employee

That would be 5.3.3 Moh.

Eddie.

Thanks Eddie, can u guide me with needed files to upgrade release to 5.3.3

ASR9K-iosxr-px-5.3.3-bridge_smus

ASR9K-iosxr-px-5.3.3

Mo, which release is the RP on now? is it running XR or it didn't come with XR installed? All you need is the you don't need ASR9K-iosxr-px-5.3.3-bridge_smus.

You just need the 5.3.3.TAR, there is one with k9 and one without it, download your preferred and just do an update. If you want to learn more about automating upgrades take a look at the following:

https://supportforums.cisco.com/document/12747091/cisco-software-managercsm-v32-now-cco

Regards

Eddie.

thx Eddie, it's working now with 5.3 and need to upgrade to 5.3.3, so is tar file is enough.

Yes easy one. Download ASR9K-iosxr-px-K9-5.3.3.tar or ASR9K-iosxr-px-5.3.3.tar

1) untar it

2) put it on your ftp server

3) From the router do an install add source ftp://user:pass@ipadd/directory/ mini.5.3.3.pie mpls.5.3.3.pie etc.. activate

Install sheet cheat if you need it:

https://supportforums.cisco.com/document/12440491/ios-xr-install-upgrade-cheat-sheet

Regards

Eddie. 

Hi Eddie,

when i boot the RSP from the first time it logged in to ROMMON, i used below steps but i don't know right mini file to use?

unset BOOT

unset TFTP_FILE

sync

unset BOOT_DEV_SEQ_OPER

unset MIRROR_ENABLE

sync

priv

diswd

IP_ADDRESS=192.168.1.241

IP_SUBNET_MASK=255.255.255.0

DEFAULT_GATEWAY=192.168.1.254

TFTP_RETRY_COUNT=4

TFTP_TIMEOUT=6000

TFTP_CHECKSUM=1

TFTP_SERVER=192.168.1.11

TFTP_MGMT_INTF=0

TFTP_BLKSIZE=1400

TURBOBOOT=on,disk0,format

sync

If you are turbobooting, you boot the mini vm file (asr9k-mini-px.vm-5.3.3).

See https://supportforums.cisco.com/document/123576/asr9000xr-understanding-turboboot-and-initial-system-bring

Thanks Mark,

I get the problem, it was when using 5.2.2 mini-vm and solved when using 5.3.3.

Moh Ka
Level 1
Level 1

I found below table for new one

Table 5.       Ordering Information

Product Description

Supported Software Release

Part Number

ASR 9000 Route Switch Processor 880 for packet transport

Cisco IOS XR Software Release 5.3.0 and later

A9K-RSP880-TR

ASR 9000 Route Switch Processor 880 for packet transport, spare

Cisco IOS XR Software Release 5.3.0 and later

A9K-RSP880-TR =

ASR 9000 Route Switch Processor 880 for service edge

Cisco IOS XR Software Release 5.3.0 and later

A9K-RSP880-SE

ASR 9000 Route Switch Processor 880 for service edge, spare

Cisco IOS-XR Software Release 5.3.0 and later

A9K-RSP880-SE =

http://www.cisco.com/c/en/us/products/collateral/routers/asr-9000-series-aggregation-services-routers/datasheet-c78-733763.html

SO, the quetion now is release 5.3.0 supporting 100G LC, or need upgrade to 5.3.3