cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
173
Views
5
Helpful
2
Replies
Ratheesh mv
Beginner

SNMP OID

I Have IOS-XR . I have total 6 BGP peers on the same box among those couple of BGP peers are belongs to global routing table(address-family IPv4 unicast) and VRF address-family .I would like to clear my doubt that is 

all BGP peers are having same SNMP OID or separate for each BGP peers or a unique for all global and a unique for all VRF ?

 

 

1 ACCEPTED SOLUTION

Accepted Solutions
balaji.bandi
VIP Expert

This OID

 

BGP Peers: .1.3.6.1.2.1.15.3.1.1

 

you can see BGP identifiers  / Local address and remote address.

 

#you can also refer BGP cisco reference - need CCO id to view

 

https://snmp.cloudapps.cisco.com/Support/SNMP/do/BrowseOID.do?local=en&translate=Translate&objectInput=1.3.6.1.2.1.15.3.1.2



BB


*** Rate All Helpful Responses ***

View solution in original post

2 REPLIES 2
balaji.bandi
VIP Expert

This OID

 

BGP Peers: .1.3.6.1.2.1.15.3.1.1

 

you can see BGP identifiers  / Local address and remote address.

 

#you can also refer BGP cisco reference - need CCO id to view

 

https://snmp.cloudapps.cisco.com/Support/SNMP/do/BrowseOID.do?local=en&translate=Translate&objectInput=1.3.6.1.2.1.15.3.1.2



BB


*** Rate All Helpful Responses ***

View solution in original post

smilstea
Cisco Employee

For VRFs you need to configure SNMP contexts. Here is a good blog post about it.

https://packetpushers.net/monitoring-vrfs-on-ios-xr/

 

Sam

Content for Community-Ad