Hi All, I just finished the initial setup for new ACI.Config the new OOB-Magement IP address for 3 APICsBut when open the "Node Management Addresses", the IP Address for APIC isn't there.However, when I open the APIC 1-3 configuration under the Syste...
Forum Posts
Resolved! finding endpoint MAC address in ACI
hello - I have only the MAC address of the endpoint. I have been asked to find which interface of the Leaf Switch it is connected to. I dont any other details like which EPG or Leaf Switch the endpoint is associated with. How to find the location of ...
I am backing out of a multipod config to recreate it again in my lab. I am to the point where I am trying to delete Pod2 and when I do I get this message: Can't remove TepPool 10.112.0.0/16 - NodeId 4151 is using IpAddress from this pool.Please chec...
Hello, i am beginer network engineer and this is my first experience with Cisco ACI. I just create a new interface profile and then associated it into existing switch profile on Cisco ACI for future needs.I have not even binding this interface to an...
Resolved! ACI SPAN Session on Spine
I want to do an ACI access SPAN Session, but I need to do it on a Spine………can I do that?
A client has aci infrastructure. they currently require port channel configuration from the two nexus leaf switches to dell servers There is some recommended guide on how to perform all the configuration from the APIC by graphical interface, the inte...
In Cisco IOS, the command to view current terminal length is `s ter | i Le` or `show terminal | include Length`Cisco_IOS#s ter | i Le Length: 44 lines, Width: 157 columns Cisco_IOS#Unfortunately, there is no such command in APIC. Please let me know t...
Resolved! L2Out Best Practices for DMZ
Hi all, We're currently working on a design for a migration from NX-OS environment to ACI, and I have a question regarding what's best when doing the L2 connectivity to a DMZ Block, since we will have several DMZ Servers going through the ACI Fabric ...
Hi all,I have an L3-out (with bgp enabled on two leaf switches) on vlan-600 that connects the fabric to the legacy part of the Data Center through a VPC. On the same VPC many other vlan pass through an L2 Domain.Now I have to extend that vlan on a po...
HiI want to upgrade two Maintenance groups, those two groups are for two different pods (1 MG each Pod)If i start this upgrade via the gui by "upgrade now" it will start one Maintenance Group immediatly and the other will be queued and processed af...
Dear Community, we have the requiremt to connect a Load Balaner and Firewall to ACI which bridge traffic between them. The Layer 3 Interfaces for the linknetwork remain on the Load Balancer and Firewall. ACI will only switch the Traffic. Firewall 10....
Hello,Can someone help me to fix this issue. I deployed service graph between two EPG's named web & app. Routed mode scenario. After deploying service graph I am seeing below fault faultMessage (Old: Major script error : Configuration error : Can't ...
Dear community, I am designing the deployment of a ACI Multipod fabric. Currently we already have a ACI fabric so the idea is to append a second Pod (Pod 2) to this fabric. Both Pods will be on separated Datacenters. First pod has a APIC cluster fo t...
Resolved! Portchannel configuration (PC Interface)
Hello All - Can somebody help the step to manually configure a Port-Channel using GUI in ACI. I dont want to use the Quickstart wizard. Thanks in advance regards,RB
