we are using vxlan,IPN, bgp evpn for aci, may i know how to check vxlan, evpn configuration from controller? do we need vxlan, evpn configuration for spine and IPN switch? thanks
Forum Posts
I'm assuming not, but wondering if ACI Multipod supports overlapping Node Ids between Pods? For example - Pod1: Spine01 Node Id = 101 Spine02 Node Id = 102 Pod2: Spine01 Node Id = 101 Spine02 Node Id = 102
Resolved! ACI Multipod APIC Initial Setup
Hi Guys, I am setting up a 3 POD Multipod APIC Cluster, the first POD is setup and discovered. The entire cluster has 5 APICs (POD1 - 2 / POD2 - 2 / POD3 - 1, APIC distributions) So for clarity on the 2nd POD APIC - Fabric name - same as the 1s...
Resolved! ACI - 2.3.1f - IP uSeg attribute missing
Hi, Our fabric has recently been upgraded to 2.3.1f. And I'm looking for IP attribute in a useg Epg on this new version. It seems only VM attributes are available ?! Previously (2.1(1h)), the IP attribute was available during the creation process o...
Apart from physical work involving installation and power up new spine switch plus cabling it with all leafs, is there any mandatory config needed on APIC side? I know we can add node id and specify OOB IP or some other things but I'm curious to lear...
in epg collection for vrf, i find the provided contract, but where is this contract defined? i want to find the parameter of this contract, i check one of my application epg, but under contract tab, it is empty.
in my vpc domain, there is no spine attached, but it shows vpc explici protection group, may i know where is this defined
may i know in ssh, how to display access policy vlan pool and attachableaccessentity profile, if i want to add one more aaep, which command to use. i have six controller, do i need to apply change on all six controller? thanks
Hello, from the ACI Multipod documentation I found two configuration parts which are not clearly explained: 1. I know there must be a extended community set on POD 1 and POD2. Following the documentation the extended community should be: extended...
we want to check in the access policy, which is the interface profile, leaf profile tied to one epg, how to find? thanks
Hello can someone list a definitive resource for ACI intra epg isolation? I am trying to figure out how to configure this and how it will work. I understand the basics, but how do you enable communications between specific hosts? Does ACI HAVE to...
Resolved! toggle between spine and leaf
I ssh into apic controller, may i know the command to enter spine and view spine configuration, after that, if i want to go to the leaf, do i need to exit to controller, or we can switch between spine and leaf?
Good morning guy, This morning, I decided to set a description on each port-channel deployed on my leaves. By the GUI, it appears that this operation is not possible. Indeed, when adding a description to a physical interface by the GUI it does wor...
Hello , I am looking to expand a cluster of 3 controllers into 5 for leaf switches scalability in a stretch fabric setup, the 5 controllers will be split into two DCs (DC-A with 3 APICs & DC-B with 2) , however the shard distribution is a concern i...
Hi, I will move server farm from legacy network to ACI, I have concern about the loop, when migrating blade servers that have switches. here the scenario: 1. I've moved vlan 10 (EPG A) to ACI, but there are still some servers that are on the N7...
