Application Networking

HelloDoes anyone know where can I find documentation on how to configure SaaS with WAAS? I'm looking to setup salesforce application on the WAAS for WAN optimization out to the branch office. All I can find is whitepapers that talks about what it doe...

Can WAAS cache HTTP without a peer device, or does it require all Internet traffic to be on the end of another WAVE appliance in order to cache. In other words, can it act like a web caching proxy ?

Greetings everyone.   I am curious if anyone has any experiences with Exchange 2013 and ACE SLB functions.  I know they changed to RPC over HTTPS on exch side and few other items changed as well.   I do not forsee any issues just looking to see if an...

Attached is a diagram  where I would like to implement WCCPv2 ...I need to know if it is possible or do i need to reshape the diagram in a new way.I know that we cannot do INLINE at the moment ....pls advice...Xperts...............!!!!

                   how to login / telnet into standby CSS?

Can someone give me the procedure details to recover the admin password for my NM-CE-BP content engine network module? I tried the documented default ID and password, but no good. I realize this is old hardware, and the topic has appeared here before...

Hi,We are using Cisco ACE 4710 to load balance servers. We have created VIP under the interface vlan using nat-pool commandAlso, we have changed the gateway of the server to point to the ACE vlan ip address which is created using alias 10.x.x.x 255.x...

Hello, We are currently running the version ACE A2(2.0), pretty old one on Cisco ACE Module.  We have applied webhost-redirection https://%h%p 302 but it doesn't seem to take effect and always go back to the host header value. Is it a bug or a missin...

Good evening,I am trying to recover a lost administrator password for a NM-CE-BP-80G-K9. I know I can establish a console session to the module with "service-module content-engine 1/0 session" (from http://www.cisco.com/en/US/products/hw/contnetw/ps7...

Hello All,I would like to find out if the ACE module/appliance can support a range command for TCP/UDP per Serverfarm/VIP.Example:My customer has an application which utilizes various range of TCP/UDP ports for servers to provide SLB. The real server...

I have a complex probe problem that I HOPE can be solved without scripting. Serverfarm "Primary" has 4 servers P01, P02, P03 and P04 all running web services @ TCP port 80. As typical, if one TCP port 80 probe fails, simply take it out of the pool an...