Application Networking

Hi all, is it possible to get the SRC NAT'ing to work in an ACE module configured in a bridged mode?We have the following set up:MSFC > FWSM(routed) > ACE(bridged)The ACE is running code 3.0(0)A1(4a).I've added the configuration of two VIP's that I a...

DearsI have 2 pair of 11501 switches and 1 pair of 11503 switches on 3 sites(LA, China, Taiwan).Each site has a pair of 1105x switch running as redundancy between them and is a standalone which will not interact with others.Recently a series of inter...

In my lab I have only one ESX server.  On this server I am running VSM and vCenter (appliance).I am trying to get 1000v working however everytime I try to migrate my ports I get the following error:Network configuration change disconnected the host '...

Dear all,I am new to Cisco Nexus 1000V. My company is considering to use a pair of Nexus 7000 as core. But to save cost, my boss wants me to connect it with a lot of Nexus 1000V switches.Just curious can i link them up like this?N7K ----- N7K   |    ...

Is it normal for me to be seeing the bounced sequence numbers of a WAAS optimized tcp stream at the client ends of the conversation?     I thought that this was something between the WAAS units themselves..       

Hi there,using the command below, I can see the Rejected Connection Counts Due To Connection Limit.Is this count based on remote-office TFO limit ? How can I be sure if this connection limis a problem in the WAAS core or in the remote-office ? I need...

Hi,I have a customer who would like to load balance two Microsoft Exchange 2010 CAS Servers which are residing across two data centers.Which is the best solution for this? Cisco ACE or Cisco ACE GSS or both?

Couple of questions for you Cisco guys. 1. On the Cisco ACE 4710 base throughput license of .5G.  What happens to the if I hit peaks of 1G?  Do you drop the traffic or try to delay it with tcp? 2. Can Raytheon move a Configuration directly from an ...

Hello,    I have two CSS-11503 in redundant mode running 8.20 code.  We had an incident in our network where a layer 2 loop caused some high traffic through the CSS' and had to shutdown some network gear(including the CSS) to clear the problem.  When...

Hi,Have an OE574 and found that it have an HP ILO enable, that we need to change from dhcp to static ip number.But I am not able to logon to the ILO interface, see picture.Any sugestion for change?Jan