Application Networking

I have a VIP, which is listening on port 8312 in ACE LB and NO probes attached to it. In this scenario how does the ACE module perform the health monitoring? Any input is appreciated.                   

On my ACE4710s I'm using least-loaded predictors monitoring Microsoft Windows CPU usage. There are times when the MS Windows CPU OIDs can change between reboots. Is anyone aware of a way for the ACE to automatically adjust to the new CPU OIDs and con...

Good day,I was presented with a requirement from a customer as follows:1. Site published to customer was http://www.abc.com2. Actual site is http://abc.com3. Requirment is for site to be accessed via httpsOriginally https configuration implemeted wit...

We have a VIP configured to carry out SSL Termination for the incoming connection and then forwards the request as HTTP to the Real (Servers.From the Logs on the  Servers it appears the ACE Load Balancer is changing the Host Header Parameter set in t...

Dear all,I read in many IT websites that Cisco has confirmed that it will end development of its Application Control Engine (ACE) load-balancer products and it will not develop further generations of its ACE.By the way, is it a correct information? D...

Hi allI was called out to a customer site yesterday as they were complaining that access to their Intranet homepage was intermittent. Every 5th to 7th attempt to open the browser (IE v6.x) resulted in the browser just 'hanging', that is, the page doe...

Hi,I'm requesting advise on problem below :- I have 2 datacenter with one server farm on each DC and 5 servers behind each server farm- each server has 5k max connection limit on each server farm- I want to be able to be able to failover to one SF to...

I cannot ping any VIP from within the ACE or from rservers.  Is this expected?  I have rservers in other serverfarms that need to be able to communicate with the VIP of other serverfarms.  Any help is greatly appreciated.

Hi All, Recently one of the WAE 512 device failed in one of the remote location, we have the new hardware now. Need help on installing the WAE1. Things to check before getting the WAE device to the network ?2. Is it simple as router or switch configu...

Dear Experts,I have a doubt.We have Primary DC and Scaled down DR working in active-standby mode. Customer doesn't own the DNS infrastructure and they are not willing to own it in near future either. In case of DC outage, they will failover to DR man...

Can somebody suggest case study for GSS. We have to demonstrate GSS functionality to customers, howevers DR site is not yet ready. Is there a way, we can showcase GSS functionality (even without failover) to customer. We have ACE installed in our net...

HelloI have an environment in which one host, from the same src ip address and src port, is sending a lot of UDP (Radius) traffic to the VIP:1812.When the rserver for this VIP does not reply to the particular UDP session (for example, the application...

            We had a hardware problem with one of our ACE 4710s,Blue light turned to flashing yellow. The console messages before it fell over were meaningless (see below)because it meantioned power our maintainer(not Cisco) replaced the Power supply...

I am interested in monitoring the performance of our WAEs using SNMP. I have had some success using the CISCO-WAN-OPTIMIZATION-MIB.I have has some success in monitoring the sessions for each AO (but it is difficult to determine which AO is which).iso...