Application Networking

Hi, We are having problems with our css11503 failover arrangement. We see  vrrp-mac flapping in the switch where the two css11503 are connected (master and backup). This behavior causes that some Cointainers stop responding requests from users. We ne...

Dear Fellows,I have the following working scenario:I am using ACE Module for Server Load Balancing in 6500. I have configured it in Routed mode.I have configured a VIP which works well from Client and Server Side. Whenever a Client sends traffic to V...

I am in the process of Migration all servers from our Content switch to CIsco ACE4710.one content has this line itemadvanced-balance sticky-srcipWhat would be similar option in ACE.?Thanks for any help on this.Mehdi

Hi Does anyone know what the maximum acceptable latency is on a FT Link between a Pair of ACE30 modules configured as a FT Pair with multiple contexts running active/active.I am trying to ascertain if it is possible to site in different DC's seperate...

Hi.We have an ACE30 (running A5(1.2)) and a couple of Exchange 2010 CAS.We have little experience in load-balancing, but we found this guide from Cisco: http://www.cisco.com/en/US/docs/solutions/Enterprise/Data_Center/App_Networking/Exchange_VSphere_...

Hi guysToday I got a customer that installed a WAE device on its LAN environment.Basically, they engineering team, for some reason, did not allow to be directly connected to our router so we have the WAE device on a different vlan from the router sub...

Dear fellows,I have the following enviroment:2 6500 Core Switch2 ACE10-6500-K9 installed in 2 Core Switch3 context > AE,CE,PE6 SERVERS -> 2 servers for AE Context, 2 Server for CE Context, 2 Servers for PE ContextDefault Round Robin Load Balancing fo...

Hi Community,I'm deploying a Cisco ACE module and I have some questions about sticky connections and about the output of the show conn command and show serverfarm command.I have the follwoing configuration:rserver host srv_1  ip address 10.4.11.14  i...

HI EveryoneIn need of some help in understanding how/where the numbers come from when looking at the how the reduction ratio is calculated.In an example I can see the following:                        Original            Optimized                    ...

Dear all,I am new to Cisco WAAS and therefore I would like to request some help regarding the following scenario:I have a star network (1 hub and 5 spoke) topology where each satellite site is connected via a 2 MB  (symmetric)  to the Head-Quarters (...