Application Networking

I have the following configuration on an ovh loadbalanceraccess-list ANY line 8 extended permit icmp any anyaccess-list ANY line 16 extended permit ip any anyprobe tcp PROBE_TCP  interval 30  passdetect interval 60rserver host app5_im  ip address 172...

Hello, I have got a problem with a Cisco ACE that send a TCP RST to clients whith low bandwith...The traffic is HTTP and I double check my loadbalancing configuration that is just fine....What can I do to avoid this problem ?Is it a TCP parameter tha...

When is Encrypted MAPI going to be Supported? I see that riverbed now supports this. When is Cisco going to?I know you can use SSL optimization but I am looking for encrypted MAPI accleration.Thanks

Hi,Last month I was reviewing following Cisco document, in which Cisco mentioned that ""To avoid possible memory fragmentation in the forwarding information base (FIB), Cisco recommends that the switch processor (SP) DRAM to a minimum of 1 GB ""http:...

Hi ,I am currently stuck with one LB implementation. I have one pair of LBs situated in DMZ zone which are load Balancing servers in secure zone as below :internet - > External Firewall -> LB - > Application ServersLBs are by passing internal firewal...

Hi,We have one Cisco ACE in our data center which is working fine but has Amber light on front & Rear.I read the document & it shows that either it is a system fault or internal fan failure.I am sure it is a fan failure because if there was any syste...

How do I apply the connection parameter map in a configuration like this to the service policy int827?  Do I need to define the traffic?  Can I specify only one source destination flow to apply the set tcp half-closed TCP normalization against?Any he...

Hi,We have 2 ACE modules on 2 6500 Catylyst swithces(those are not connected directly). To acieve FT design do we need to cross connect these 6500 swicthces? Both 6500 switches are uplinked to GW routers and those GWs are cross connected.Just wonderi...

Hi folks,Some assistance if you have the time please.I'm running an ACE 4700 appliance, i have a 4 server serverfarm setup, non-ssl, with leastconns predictor...i have tried round robin as well, and nothing...I've taken each rserver out of service, a...

Hi,Is it all possible to use an ACE30 to RHI a VIP which acts as route for servers on LAN A to reach LAN B . We have 2xL2 WAN circuits between 2 sites used by only 4 servers for (different L3 subnets for the hosts). I`m considering using a VIP to loa...

Dear,My customer want to install a WAAS in six local remote site and a Site Central, but He has a ALLOT NetEnforcer, the Allot is doing Traffic Prioritization now.I will apreciate some comment about I can install the allot with WAAS.I am planing to s...