Application Networking

cancel
Showing results for 
Search instead for 
Did you mean: 
cancel

Cisco UCS X-Series Energy Efficiency Offer

 

Forum Posts

Hi all,ACE20 module with A2(3.3)I have tried to config a NAT-pool with two adresses, but only one is used. class-map match-all NAT015_VLAN702  2 match source-address 192.168.137.93 255.255.255.255  3 match destination-address 192.168.137.0 255.255.25...

mruuth by Level 1
  • 1921 Views
  • 6 replies
  • 0 Helpful votes

I'm currently load balancing a couple FTP servers and the vendor is asking me to make sure to have IP passthrough and no header rewrite. I believe he is looking at a different company LB. What is the Cisco terms for that? Is this something that I nee...

Don Brack by Level 1
  • 483 Views
  • 1 replies
  • 0 Helpful votes

I'm configuring ACE to enable the XML-HTTPS interface so I can import it into ANM, when I try to do a "match protocol xml-https any", I get a invalid command detected. When I tab at the match protocol command, I don't see xml-https listed (http, http...

kevin.keo by Level 1
  • 1674 Views
  • 2 replies
  • 0 Helpful votes

folksi've inherited a cluster of CSS11501s and i'm never really used them beforecan someone point me in the direction of a good troubleshooting guide please?i'm running CSS11501# sh versVersion:               sg0820101 (08.20.1.01)Flash (Locked):    ...

Hi AllI currently have a requirement to run a ACE context in a bridged mode which has groups of servers that need to source NAT'd to single addresses for outbound connections to single internet host. Connections are sourced on the 'server side' ACE i...

mj11 by Level 3
  • 627 Views
  • 1 replies
  • 0 Helpful votes

Dear All,i am having issues deploying Cisco WAE 7341 & WAVE 247 in a datacenter. I need a brief installation steps to install both equipment , and connect both into the network using the right cable and ports , such that the device is visible on the ...

okoroji80 by Level 1
  • 738 Views
  • 1 replies
  • 0 Helpful votes