Application Networking

Dear all,I configured an ACE in bridged mode (inside vlan: 2012, outside vlan: 2021) and I apply the L4 policy on the 2 VLAN interface to loadbalance HTTP incoming request (Virtual IP: 172.22.22.130).interface vlan 2112  bridge-group 1  access-group ...

This has already happened before.A Stop&Start in the WAE Web Management browser resolved the problem before.Now it never starts. Any ideas ?WAE-612-2G - WAAS-4.1.3a.32Best Regards,Bruno PetrónioDC-WAE-LISBOA#show alarms detail Critical Alarms:------...

Is it possible to prevent WAE devices from optimizing traffic from end to end and instead having it optimized twice for the same connections?I am trying to set up an optimized Secure FTP connection between one of our offices and their client. However...

Hi, One of my customers WAE-674 working in Accelerator mode got faulty and we have received a replacement from CiscoCustomer purchased WAE with Enterprise license but I am unable to find the Enterprise license number new WAE-674.Are these license pre...

Hi people,I am hoping you can help me. I have inherited a bit of a mess on my current job. I think I have it right, but it is not working.We have a 6509 with an ACE module. For reasons I dont fully understand the ACE is running using a BVI in bridge ...

Hello!!A customer wants to configure SIP in the LB, but we noticie that their handsets use the abbreviated form of common header fields. Does the ACE supports the compact form of SIP?? We will use the sticky feature for the requests.Thanks!

Hi, I know there is a 200,000 limit on concurrent connection on our CSS devices, but is there any way to see how the CSS has behaved historically in terms of the most concurrent connections there has been on the box at a time, average concurrent conn...

We just got RMA Cisco WAAS Devices (WAE 512) from Cisco. We decided to test the devices before taking it to client sites. The 2 devices could not boot, it display following error message "I9990301 Hard disk drive boot sector error". We transfer hard ...

Our standard WAE design was to have dual WAE's at sites with dual Routers. The WAE's are either 674's or 574's and the routers are Cisco ISR's all works well.Several new sites have coome online but these sites now only have a single WAE devcie and tw...

HiDoes anyone know if you can assign mutilple keepalive non-contigous port numbers to a single service.For example port numbersKeepalive port 1966, 1976I know about the range configuration, which is useful if the port numbers are contiguous, but are ...

HelloI have one WAE 674 at the HO and many 274 at the Branches all with version 4.1.3b .Can i upgarde the one at the HO to 4.3.3 ? will this cause any problem?What is the procedures to perform upgrades ?Regards,George

I have a branch deployed with an appliance using WCCP and I just purchased a module for a smaller site. I am having trouble equating wccp config over to the module. Read all the white papers but I am missing something really simple.I will apreciate t...

Need help in configuring SSL offload for sendmailWhen users access the VIP ,the VIP need to commnunicate to the internet goole via outbound eternal email (smtp) smart. and the host is outbounds.200.obsmtp.comuser to vip in HTTPVIP to google(internet)...