Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello, I have a requirement to load balance between real servers on different subnets, but I need to preserve the original source IP address through the ACE. I know the ACE can do Asymmetric server normalization but that appears to require the serve...
Hi,I am wondering is it possilble to determine to which server would a request go to when using destination address hash? or at least how does the mask work? I would have assumed that with mask 255.255.255.0 only last octet would be considered for th...
GreetingI have one VIP caused overload my css5-ssl-k9 module. I expect that the service should be suspended automatically, but, it looks like if there is overloading on backend server, and than the ssl module will overload and the whole CSS system wi...
We have quite a few certs that we need to import into the ACE SM, running A2(2.32). Is there a way to import them all at once as opposed to one by one?Thanks...
Hi AllI have two old CSS 11500 that are doing nothing but providing load balancing for 2 terminal servers.As per the documentation, I setup my ASR config (at least i think its right). I'm now faced with two problems:Problem #1: If I suspend the fir...
We're atttempting to optimize a connection to a VIP on the ACE load balancer from the client PC. We have an optimizer in the Data Center that peers with an optimizer in each client site. The back-end servers that the ACE load balances the connection ...
HelloDoes anyone know what the default behaviour for URL Hash is on the Cisco ACE and what it was for CSM?I see you can set start and end strings to look for in ACE, when this wasn't avaliable in CSM - I'm wondering what the default behaviour is in A...
I was operating CSS as One arm mode with multiple Cclasses which was working fine but the problem wasStats which only showed CSS as the client IP address.So the config was like thiscircuit Vlan 1ip address x.x.x.2ip address y.y.y.2ip address z.z.z.2i...
I have an FTP transfer that fails after what appears to be exactly one hour through a transparent ACE. ACE is not natting to the rservers. When I put the server infront of the ACE, the transfer completes fine. Does anyone know what is causing this...
Hi,I have Cisco ACE 4710 appliance with version A3 (2.4) that is synchronizing time with NTP server in internal network. I am looking for enabling NTP Authentication in ACE. Is NTP authentication supported in any of the latest versions of ACE?Thank y...
Hello,We have CiscoWorks and Cisco Security Manager in our setup. And we would like to record/archive the rserver/serverfarm connection statistics from ACE20 Module. CiscoWorks is only able to pull CPU & Memory stats.Is there a way where connections ...
Hello,I would like to restrict VMotion traffic to 2 Gig max. What is the easiest way to do it? My VMotion subnet is 10.1.1.0/25. Below is my show version output on my Nexus. Your help is greatly appreciated.Thanks,Software BIOS: version 1.2.0 ...
Hi All ,I hv 2 servers for load balanced http traffic on ACE configured in context mode , Need configuration help to configure load balancing on a single server based on ports 80 and 8043 .I need one http request to be load balanced on two ports 80 a...
I have a site which has a WAVE-574-K9 installed and the CIFS cache is currently running close to the maximum disk size. vThe VB capability of the device is not currently required, so I would like to know if there is any way to free up the portion of ...
