Application Networking

We're configuring the ACE SM and can;t seem to access the backend servers on certain ports (7774, 44440) from the server sitting on the VIP vlan in front of the ACE. We have applied the "ip access-list any any" to both interfaces on the ACE, but to n...

can cisco WAAS accelerate GRE trafic?

Hi Experts,I am not able to upload the firmware on the ACE module.Laptop--consolecable---ACE modulerommon >Loading disk0:c6ace-t1k9-mz.A2_1_6.bin. Please wait .... file(disk0:c6ace-t1k9-mz.A2_1_6.bin) open error loadprog: error - on file open boot: c...

We're configuring the ACE and need it to be able to handle the 304 and 307 tyoe of rewrite/redirections that the back-end servers are doing. We have successfully used the following command for the 301/302 redirection: header rewrite response Location...

Hi,SVI Interfaces are supposedly for communication between the MSFC and the ACE. So the commandinterface vlan 250 configured on the 6500 Switch would enable SVI on the MSFC. In our setup we have multiple contexts on the ACE and our VPN box sits behin...

Hi All,Try to configure ACE as reverse proxy for WebLogic server farm. But have a issue on Rewriting URL.http://172.16.36.100/test1/ -> http://192.168.1.20:8080/test1/ This is Possible.But, http://172.16.36.100/test1/ -> http://192.168.1.20:8080/test...

Hi,From a architectual point of view, when does the WAE delete old cache. When the hard drive fills up how does it know what information to delete?ThanksBrad

Hi ,I have CSM module on the cat 6500 switch and the issue is the content switch module is not balancing the request to the servers.IT only sends to one server were as it should do the load balance and send it to all the servers packets by packets.Ki...

Currently CSM1 is active and CSM2 is standby.All the traffic currently flowing though the CSM1 which is currently Active which is perfectly correct. Now we Need to check the redundancy behaviour by bringing down the CSM1 and make CSM2 as active so th...

Hi,I am not able to save the configuration on the ACE module.Admin# wr memGenerating configuration....Error in generating running config..copy aborted"Write memory failed for context Admin"Any help would be appriated.ThanksNeha