Application Networking

Currently CSM1 is active and CSM2 is standby.All the traffic currently flowing though the CSM1 which is currently Active which is perfectly correct. Now we Need to check the redundancy behaviour by bringing down the CSM1 and make CSM2 as active so th...

Hi,I am not able to save the configuration on the ACE module.Admin# wr memGenerating configuration....Error in generating running config..copy aborted"Write memory failed for context Admin"Any help would be appriated.ThanksNeha

Can anyone tell me what the best practice is for the ACE 4710 appliance. Should I deploy it in routed mode or source NAT mode. And what can be the pros and cons of each method....

We have share point instances that we site select direct servers (not LB) and would like to probe the main page with support of authentication. Is this anyway possible to do directly from the GSS or something best suited to front it with a LB. We hav...

Hi ,I am not able to telnet to my ace module please see the error/msg i see when i try to login:- [Switch6500]$ telnet acemod2Trying 10.10.10.2.Connected to acemod2.asia.comacemod2 login: adminPassword:Context not found, called API timed out[Switch65...

Are there any books written for the ACE?

I'm getting ready to upgrade two CSS's in box-to-box redundancy mode. The upgrade is simple enough, but what are the best practices for two boxes in box-to-box?I suppose I can copy the software up to the master box. Then force the standby box to be m...

Hi everyone,We are trying to plan a topology for FWLB with ACE. We have a FWSM with one outside, and multiple DMZ/inside interfaces. This FWSM has to be duplicated because of performance.We thought of using ACE in multiple context mode to perform FWL...

Hi,I am getting this error message on the ACEConfiguration replication for context Admin will not happen: Error HA election timed out. I tried to reload the ACE since the standby ACE was unresponsive and showed the followingpeer state: FSM_FT_STATE_U...

Hi,The customer ask me if there is a way to redirect the traffic going to a datacenter to another backup datacenter when the first is not reachable anymore.I would use the ACE functionality called "cascade Redirect". Is it correct? I would like to kn...

Anyone know if you can monitor a URL with the CSM in a 6500? Im wanting to monitor specific URLs to make sure they are up, and not sure how. Anyone know if this can be done and maybe how to configure it? Thanks.

Hello,My standby ACE has gone to unresponsive mode and shows something like this peer state: FSM_FT_STATE_UNKNOWNThis is for all the contexts in the slot module. My question is how do we bring it back to HOT_STANDBY when all contexts are unresponsive...

Hi Experts, I have Two ACE modules in bridge mode and its configured as active/standby. But I cannot ping to the gateway from standby ACE. from the msfc side all the configurations are ok. Could you plz help us to find the root cause of this ?RgdsAsl...

I like to copy and paste optimization charts and graphs from CM GUI to a Word document, but have not found a way to do it. Can someone help me out? Thanks a lot