Application Networking

I'm trying to copy a cert/key combo from an active context to the standby (which is in standby_cold), and I'm getting this error:Error: Error in reading a local temporary file.I'm using the command: crypto import terminal www.test.com-certI can't res...

Hello,I've found, what i think is a bug, in our CSM and want to share, and hopefully you've something to add (or solve?)cisco CSM software 4.2.11 on a 6509 chassis, software 12.2.18 SXF15aWhen configured a VIP with either ssl stickiness or regular st...

Dear experts, I have to configure two ACE 4710 in high availability. The customer pak includes:ACE-4710-BAS-2PAK 2 Units of ACE 4710 Hardware-1Gbps-1K SSL-100MbpsComp-5VCACE-AP-SW-3.2ACE-AP-BAS-LICThis is my first time working with ACE, my experience...

I am having a redirect/rewrite problem with my ACE module. When the user types in https://citix.com and accepts the cert, I need the ace to add the following path to the url.../citrix/accessplatform/auth/login.aspx. That part works, but the page is...

I knew FT only work with pair of ACE hardware.I have this design where there site A Data center and site B as Disaster Recovery. Both sites each have 2 units of ACE. The internal server farm VLAN as extended from DC to DRC, it mean L2 LAN is extended...

Hi - I'm having problems monitoring a pair of CSS in an active-standby cluster:I can ping the management address of the active device OK from a different subnet, but not the standby device, yet I can ping the standby from the local subnet.If I force ...

new to ace just purchased a new blade, could somebody advise on deployment in routed and single arm mode. if a client connects to the vip can the traffic route back out the vip interface to the servers. we have a dmz were we want to deploy a vip, onc...

dear allis the ACE module support IPV6?best regards

Hi I'm very new to the ACE module and need some ideas on a problem we had a few days ago. We have an ACE in a 6506 that stopped passing Internet Traffic for a period of time. It was reloaded twice but only after the second reload did it bust into lif...

Hi,I need to configure ACE for load-balancing FTPS. And simply deploying L4 policies are not helping either. Configured the FTPS servers and both of them are working fine when accessed via physical IP, but do not work when accessed via the VIP. if it...

I am getting up to speed the ACE module and seeing lots of cases where an alias is configured on both, the client and server side vlan interfaces. Is this a requirement?Thanks..

Hi all,Does anyone know if it is possible to setup IOS SLB in a way that if half of a serverfarm servers are down the whole serverfarm goes offline?This is easy with ACE, but I can't seen to find a way with IOS SLB.Real Thanks to everyone,Claudio.