Application Networking

Trying to get an ACE blade to do L3/L4 load-balancing in one-arm mode, but using PBR rather than source NAT.Got a base config together and load-balancing seems to be working Ok. The problem I am trying to figure out is how to deal with direct flows,...

Hi all,After configuring ntp server, the time is syncronized with no problem at all.The issue occurs when the router reloads/turns off, and when it goes up, the hour in the NM-WAE, will never sync automatically.I always have to delete the ntp configu...

Hi, Can we offload SSL for ftp onto ACE, like we do for https. I need to configure ACE where i want the clients to connect to ACE via FTPS (989, 990), and ACE in terms connects to the FTP server via normal FTP (20,21).

hello,what is the rigth syntax to use within tcpports scriptlooking to have multiple ip address and multiple ports. the e.g. file has the following line echo "Usage: ap-kal-tcp-ports \'ipAddress tcpPort1 [tcpPort2 tcpPort3...]\'"will it be \'10.1.10...

Is there any way we can we use the etherchannel type of things for providing more bandwidth and also providing resliency for interface failure.

Please could someone guide me in the correct direction. I have a CSS 11503 that I am using in a test environment and I want to be able to terminate SSL to the device and then balance unencrypted to back end web servers. When I bought this I read the ...

We're in the process of configuring a load balancing to the farm on the ACE module. We have been given the VIP and the port (80) in conjunction with the VIP. Do we need to configure a Layer7 class-map first and then a Layer3-4 class-map or just a Lay...

This has probably been asked before but when using CSS Load Balancers to balance traffic to Web servers how do you then directly access each individual web server for configuration and local LAN updates etc?Only external connections to the web server...

Hi,currently i have two CM. A primary and a standby. As a requirement of a DRP site i have to deploy another standby CM. Is it possyble? there is any restriction on the number of standby CM?thxRafaelgc

Hi guys, would like to check out what's really the logging telling and what's the problem it will be. I have 2 unit of 6500 boxes with CSM. The topology is doing in single subnet mode. The server NIC is doing in SLB, where 1 primary 1 standby, and th...

Does anyone have the generic visio icons that cisco use in the documentation.I have got the physical device view icons from CCO, but these are the only ones i see to download. I have already searched through the stencil index on CCO & the NM-WAE is n...

Currently we have two older applications using sql that inhouse run in less than two seconds. Over the waas and 60 ms latency run 3 to 4 minutes. I am looking for any assitance on this. We have tried changing from passthrough to full optimization.