Application Networking

cancel
Showing results for 
Search instead for 
Did you mean: 
cancel

Cisco UCS X-Series Energy Efficiency Offer

 

Forum Posts

Hi,I have configured 2 resource classes in ACE as follows:resource-class BE-Nonprod limit-resource all minimum 20.00 maximum unlimited limit-resource sticky minimum 20.00 maximum equal-to-minresource-class FE-Nonprod limit-resource all minimum 20....

nsyal by Cisco Employee
  • 2516 Views
  • 7 replies
  • 0 Helpful votes

When monitoring a specific flow on our CSS, "show flows" command output does not show this flow even when the user is actively using the content rule/ service. flow-timeout-multiplier has been set to 225 (1 hour). See below output when the "show flow...

Hi all, thanks in advanceplease suggest me what is the reason for interface pos1/2/0 to be up,protocol downsh ip int pos1/2/0POS1/2/0 is up, line protocol is down Internet address is 10.197.208.1/30 Broadcast address is 255.255.255.255 Address det...

Hi,I have 1 ssl-proxy-list with 3 virtual ssl servers defined. I also have the ssl-proxy-list added to several services. I need to add the following to each of the 3 servers:ssl-server 3 tcp server window 40960ssl-server 3 tcp virtual window 40960Sam...

mduhra by Level 1
  • 2034 Views
  • 11 replies
  • 0 Helpful votes

Hi,I have configured http-cookie based stickiness. When i am executing "show sticky database sticky http-cookie <cookie-vlaue>" it is not showing anything. But when i am executing the command "show sticky database sticky" i am able to see the entries...

nsyal by Cisco Employee
  • 1681 Views
  • 6 replies
  • 0 Helpful votes

I have wae612 with last version of ACNS on it.I run it like a transparent proxy using wccp v2 together with cisco7206.If I test caching with only my PC - WAE612 performs great.Problem - when I divert all customers' traffic to WAE - it begins to downl...

Problem Details: Configured CSS 11501,in active/standby mode, I need configurationassistance where in whenever our application connects to the load Balancer it should stickto that particular server and it should not time out at all.Any configuration ...

iexsystem by Community Member
  • 836 Views
  • 2 replies
  • 0 Helpful votes