Application Networking

cancel
Showing results for 
Search instead for 
Did you mean: 
cancel

Cisco UCS X-Series Energy Efficiency Offer

 

Forum Posts

Hi there,I'm having some problems with Content Engine.I would appreciate any help.It gives following errors:Jun 12 08:15:59 CE01 wccp: %CE-WCCP-5-500008: WCCP: A new view fromthe 25.25.25.25. Change number = 28Jun 12 08:15:59 CE01 wccp: %CE-WCCP-5-50...

sufle by Level 2
  • 734 Views
  • 2 replies
  • 0 Helpful votes

This is a two questions part. Can the service type "nci-direct-return" be used with a remote webserver not in-line with another CSS?Also can the return path be forward to the originating CSS instead to the client who request the content?

gplouffe by Community Member
  • 534 Views
  • 1 replies
  • 0 Helpful votes

I have all my WAEs configured for NTP with a router acting as the Master NTP server. This all appears to work fine when I check the clocks from the CLI. They all show UTC -5.My question is why do the Connection Statistic reports on the Central Manage...

pmccubbin by Level 10
  • 1008 Views
  • 4 replies
  • 0 Helpful votes

I am having trouble locating a document that outlines the amount of disk space available for file cache for each of the WAE models. The models I am considering are the NME-WAE-502 (we use 2800 series routers so this is the biggest NM we can support),...

pthaynes by Level 2
  • 1223 Views
  • 2 replies
  • 0 Helpful votes

I'm using CE560 to control the traffic for our users . Normally users are putting the IP for the CE560 in IE and proxing internet , by doing this way im unable to browse https sites "https proxy incoming 80" im trying to put the above commands ,but i...

Haris P by Level 7
  • 614 Views
  • 1 replies
  • 0 Helpful votes

Hello,I am trying to get WCCP working on the ASA for WAAS implementation. Here is a simple snapshot of my config:Eth 0/0 : Outside (to internet)Eth 0/1 : Vlan1 (20.20.0.0/16) (trunk port to remote office LAN)Eth 0/1.211 : Vlan211 (20.21.10.0/24)Eth 0...

Hi All,I am new to CSS Loadbalancing devices. I would like if IPv6 support is there in CSS. I would like to have 2 web servers with same content one in IPv4 and the other in IPv6. CSS will forward the traffic to IPv6 server if the source is IPv6 and ...

Hi there,I have a probe and it keeps failing. I believe it might be something to do with the special character in the URL. The URL requires a port then a page after the server address:probe http Server2_Probe description Checks Server2 http is respon...