Application Networking

I have a sticky serverfarm configured with a sorry serverfarm for when the site is out of service. All works well when i take "rserver host "TEST.MICROCHIPDIRECT.COM_01". The requested then hit the "TESTBOX" which is the out of service page. Theprobl...

Is-it possible to test CIFS connection with probe ?We need to check that unc link is ok (read or write).Are there some TLC script usuable ?

I'm looking for both Cisco internal and external training on ACNS, ACE, WAAS. Any help would be appreciated.Thanks

If using arrowpoint cookie balancing to stick a client to a particular service during the session what happens if the client doesn't send the cookie? There's an application that does this when looking at a trace on the client side:1) start TCP connec...

Hi,In WAAS GUI, we have an option to change the priority of the defualt policies. Is there any recommendation about changing the priorties as per the traffic flowing in our network or can we leave it to defaultThanks in adv,Guru

Redundant SCM does not boot in a CSS11506The boot file is as follows!************************ BOOT CONFIG ************************ primary boot-file sg0810107s primary boot-type boot-via-disk passive primary boot-file sg0810107s passive primary boot-...

Is it possible to have a vlan associated to vlan-group of both ACE AND FWSM ? For example to let ACE connect to a management vlan which is firewalled by the FWSM. Thanks a lot! Greetings, Wim

Has anyone else experienced an issue with the WCM group configuration unexpectedly removing other commands from a WAE?An example of WCCP configurations in a WAE: wccp router-list 1 192.168.253.98 192.168.253.99 wccp tcp-promiscuous router-list-num 1 ...

CSM's have a limitation where the control processor can only manage 200 current health checks at one time. This problem arises if you have a number of serverfarms and a probe with short intervals like 2 seconds, if the 200 limit is reached which has ...

I'll post the relevant part of the config below. For testing I've made a self signed cert. The VIP address is 10.10.15.84 and the server address is 10.10.12.84. I can connect fine going to the VIP address on http but when I try https nothing comes up...

Hi to all, i've configured an ace module to load balance traffic on transparent firewall.this is the relevant part of the configuration:access-list ACL1 line 10 extended permit ip any any probe icmp VDOM_FAILED description VERIFICA LO STATUS DEGLI R-...