Application Networking

I have setup SSL termination on the ACE. The client is prompt for the certificate, but when client accepts the certificate the web page is not displayed. I look at the connection table (sh conn) and it shows that it is talking to the real server(s) o...

Hi allI have my CSS's located behind firewalls on a private subnet. The firewall is performing NAT for external translations to my VIPs. I am implementing GSLB for failover and want to know if it is possible to do this with this configuration or if I...

In order to configure GSLB with the CSS's, what ports do I need to open for the CSS's to talk to each other and maintain state information?Thanks

Hi,What is the platform of the CSS OS ( for example : Linux, Free BSD ... ). Is there any known issue that can hijack the CSS? The CSS of my customer sent many unknown icmp packet, how can I debug it?Best Regards,

Hello Everyone!I've got a Cisco 200 Micro Webserver (mweb200) with a damaged scsi harddrive.I've ordered a new one now , but i dont know how to format it when i will put it in the micro webserver. The documentation clearly says "The Micro Webserver 2...

Dear All,I have some design questions that related to CE-7326 with ACNS 5.4 and its embedded Websense s/w ver 5.2 the questions are:1) is it possible for the embedded websense s/w to block any TCP user traffic? if yes, does it use the TCP RST flag te...

Hi,I have a portal of eight real servers and one sorry server, which should redirect new user to another portal, in case of an overload condition of all eight real servers. Server load is measured on each real server using a custom developed agent, w...

Hello,I was wondering if someone ever tried to loadbalance Windows Media Servers with an ACE blade. I know RTSP is supported by the ACE, but what about Microsoft MMS ?Thanks for any comments or sample configVincent

Hi, I have configured a front end SSL connection to a single server, traffic hits the CSS on port 443, is decrypted and sent to the server on port 81.When I look at the flows I can see the correct from of traffic, port 443 from my PC to CSS, sent to ...

Hello all,has anyone been able to successfully configure the ACE board to initiate and terminate ssl connections as ssl client. We tried a lot, but no luck... Is there a working configuration example out there, because the documentation does not tell...

I'm configuring our content engine for web caching.What does "vary user agent" do, and how do I set it up?I read the config guide but it doesn't explain much.thanks.

Dear All,I installed the blue coat on one of the vlan with users in diffwrent vlans. The core 4507R is used with L3 vlans as gateway for the respective vlan users. Now i need to configure both core switch and blue coat as proxy server so that all the...

what is the impact to the cpu of the ssl module if we change from 1024 to 2048 bit keys?Actually we have more than 60% of cpu on the ssl modules. So it would be nice to know the impact on the css prior the change.Andre

Good Morning.I've got a question on how to combine subnets. I have 3 small closed networks, all utilzing a ip range of 192.168.1.xxxThese networks have no "outside" connectivity to the world and are located in 3 seperate physical locations. To allow ...