Application Networking

Hi, I'm looking for CSS11503 switch documentation (installation, different configuration types with scenarios and troubleshooting). I couldn't find the documentation on cisco's web site. All I got is product literature. I would appreciate if anybody ...

All our internet services like mail,SSL,FTP and http are hosted at one location.this will be our single point of failure, recently we had come up with DR site having all the services which are available on primary site. Using CSS11000 switch want to ...

As a followup to my last message, the config I'm using is as follows:ssl-proxy-list clear_ssl_list backend-server 1 backend-server 1 server-ip x.x.x.x backend-server 1 cipher rsa-with-rc4-128-md5 backend-server 1 ip address x.x.x.x active service CL_...

Hello,I have a CSS 11500 and i have Linux-box witch Apache software is running.Whe are running on this box Reverse-proxy machine.And the IIS (web-server) is in the internal network.Can I monitor the Linux-proces with the CSS, and if the proces failed...

I have an 11506 connect between two 6500's. All the servers use the content switch as a gateway. I was trouble shooting a problem when I noticed that if I bypass the vip and hit a web server directly, the flow "show flows x.x.x.x" stays there for alo...

When I configure sticky option on contents as follow content www vip address 172.16.1.1 add service web1 weight 2 add service web2 weight 3 add service web3 weight 4 balance weightedrr advanced-balance sticky-srcip sticky-mask 255.255.255.0 protocol ...

I am trying to setup VIP redudancy and would like to understand what circumstances cause a failover for the VIP. An example of what I would hope it does is if a redundant interface were to failover the VIP could be associated with it and failover as ...

we are ISP and we have been using two cache engines in our NEtwork one is 570 and another is 550.But we are facing some problem since last month .The actual problem is it works fine and suddenly the browsing becomes very very slow for around 20 minut...

Hello, I am configuring the the above device, and would like to know how do I update the OS to 4.1 version and how to import the IIS 5.0 certificate and key into the Secure content accelerator config manager. I also need the 4.1 IOS to upload it to m...

Hi.I've defined a service as the type "ssl-accel-backend ". When I try to enter the "active" command to activate the service I get the error message "BAD IP ADDRESS".I've run out of things to check. Any clues??Cheers

I have 2 identcal web servers. I want everyone to ba able to access 1 web server ( which they can) and I want to specify only 1 network to be able to get to the other server (for testing rollouts , etc). Any good tips on how to get this done with a C...

In a GSLB environment running on CSS's is it possible to advertise the same VIP address from two different sites to achieve a DNS based Anycast solution with traffic routing to the closest VIP. I understand there is a restriction with the CSS which p...

Hello all,I've been tasked to setup up FWLB with CSS 11503's as shown below. The issue is that intranet workstations use VPN client software when connecting to certain sites through the Internet and other times they use http or https (for connection ...

Hello: I am trying to stream WMT from a pre-loaded Cache engine through a PIX firewall. I would like to use UDP for the streaming, but when I start the streaming TCP is selected by default. Forcing UDP within Windows causes an error. The PIX doesn't ...

Can a CSS11500 load balance and health check real servers that are several Layer-3 hops away from the VIP on the CSS. All documentation and examples always show the servers connected to the CSS as Layer-2 If yes are there any limitations using a CSS ...