Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
We have a WAE device that isn't using https yet https services are running on the device. This triggered a security audit to kick it out. is there any way to disable https services from running on a WAE device?
Hello,We are running 4.1.5f on a 7341 attached to a 6509 using Layer 2 Mask Assign. We are getting the CIFS keepalive error:MRG-WAE-01#show alarmsCritical Alarms:----------------NoneMajor Alarms:------------- Alarm ID Module/Submodule...
Hello,I have been tried to migrate from CSM to ACE module on 6513 box and convert a CSMconfig to ACE config with csm2ace tool. And do not quite understand how to solve anissue with vlan's default gateway. See an example below.I.e. on CSM there are- c...
Hello,I configured icmp inspection on the ACE module [system:Version A2(3.3) [build 3.0(0)A2(3.3)] but I'm not able to see any packets in counters with show service-policy name, all counters are empty. How would I see if icmp packet inspection is ope...
Hi,I am in the process of changing my CSS to ACE however I faced an issue. For the CSS, I am able to configure destination port and destination IP stickiness for the load balancing but Cisco ACE does not have an option for destination port stickiness...
Hi,Anyone knows how to the load balance windows printer server (windows 2008 R2) with a pair of 4710 (Ver5.2), especially the windows print service probe setup ?
Hi,On ace4710 I have many context and in each context there're a some class-map and I had removed two of them!Now, customer could not reach this context BUT this context is up and running and could connect to the server...====================Actually...
Hi,Configured a new context with the GUI, deployed it and the ACE reloaded and entered initial configuration mode! The peer device took over, a restore all was performed and the ACE became primary once more, the peer is now in standby cold.A show ver...
Hi All,I'm working on troubleshooting Intermittent application access. probe was getting failed intermittently.Is it possible to run any script on ACE which will do the packet capture only if the probe failed to an application?Regards,Thiyagu
Hi All,I have cisco 5020 nexus switch which is currently running with kickstart: version 4.0(0)N1(2)system: version 4.0(0)N1(2)I want to upgrade for kickstart: version 4.2(1)N2(1)system: version 4.2(1)N2(1)i believe it requires chain upgrade , ...
Hello everyone,I've been detect a problem on a WAE-7371-K9 on its DISK00.==================================================================================================WAE-7371-K9#show disks detailsRAID Physical disk information: disk00: Defunct ...
Hello,I was reading the ACE docs and it sounds like the startup-config file should be listed under disk0: but I don't see it there. Can someone point out where the startup-config file is.ThanksMike
Hi Team,I have one Cisco 1941(ISRG2) router.I am able to redirect the HTTP traffic. I am unable to redirect the other than HTTP traffic. We need to redirect the HTTPS traffic.Can you share any example configuration for redirecting the other then HTTP...
A customer wishes to issue their field service engineers with smartphones which will enable them to conenct to the MS Exchange CAS hosts installed in our data centres using MS Activesync. The connections will be using HTTPS and they wish to enable se...
