I encountered same issue but i found out that there was some configuration pending deployment, I was able to resolve it by deploying the pending configuration on FDM. Thanks.
Every single upgrade cycle since X8.10 we have to factory reset our entire cluster of Expressway Cores and Edges in order to get them running properly again. Is everyone running into this issue? What is Cisco doing to mitigate this problem? It's been...
I ran into this bug due to a failed node addition/cluster expansion. I was adding a brand new converged node, and it failed on the second to last step of the workflow. The node was partially added in: it showed in HX Connect and vCenter, but storag...
We really really REALLY want this too. We have a service model where our staff are asked to do work at different locations frequently but we can't do extension mobility for everyone (nor does it make sense when simply working from the office next do...
Hi, Am facing issue with Call variable Layout. For few of the agents, Call variable layout is pop up is delayed. Some times call variable layout pop up is disappeared even before the call gets disconnected. Finesse Version: 11.5.1 with ES02 Regards,...
I was just told an employee was having 'Restricted' calls with his Galaxy S7 and he is 8.0 OreoI pulled up all the 12.8 Jabber caveats but did not find any specific mention of Galaxy S7 issue and pretty sure we have other Galaxy S7's in our Enterpri...
Additional info. Just installed 15.2(7)E on a couple of 3560CX's:= "snmp mib flash cache" reappears if the switch is restarted. Workaround must be applied each time.= snmp changes of any kind require a restart of the switch. Anyone have 15.2.7E0a(E...
We are getting below error and switch reboot frequently , we are using SG 350 - 28 port switch.%SYSLOG-F-OSFATAL: caught segmentation fault exception at address 0xc signal-num = 11 (SIGSEGV) signal-code = 1 (SEGV_MAPERR) reg[00] = 0xaa105604 reg[0 1]...
Is there any workaround for the case?Is the only solution to poll first the ent table to discover the indexes of the required things to poll? (PSU, FAN, chassis...)Can anyone advise other method to implement this in a smart way?
We have a couple Cisco SX20 video conferencing units. They had up until this semester been working fine. This semester we are experiencing high packet loss outbound only (we can see and hear everyone fine but they get jitter and dropped audio). We ha...
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: