Cisco Bug Discussions

Large hospital network...after upgrading from 8.10.171 to 8.10.181, clients trying to use 3802 APs were unable to use most applications due to slowness.  Moving the AP back to 8.10.171 resolved the issue.  Didn't see the problem on our 3702s or 9130s...

We get these nuisance alerts intermittently approximately weekly from different HyperFlex nodes in two clusters with a total of 8 Optane/NVMe M6 H240c UCS HX servers. Cisco is indicating it is "cosmetic" only. Seems pretty specific (raised F1947 erro...

We had similar issue to the one described in CSCvz71596 and CSCwd54400 on the 9.18(2)5  ASA code. When creating new context, context subinterface assignment was not applied on standby unit and "Number of interfaces on Active and Standby are not consi...

Is there anything else that needs to done after applying the workaround? Any reload of the WLC, APs or does it need time to sync? Or should it work automatically?

Just curious if anyone has heard anything from Cisco Engineering about whether the recommended release for 9300 series switches is impacted by this bug?  The known affected release happens to be the next minor release after the recommended.  I can co...

This problem is also present in DNAC version 2.2.2.9.  Correct? A fix is not available in the release 2.2.2.9.

Hi,  I have checked and the DHCP reservation doesn't support on 7.2 either.  is there any ETA?         

When attempting to add certain ONVIF devices, the VSOM GUI shows the following error: Operation Failed: Media server reported the error Failed to add the ONVIF profile in the device.

I need this Bug to be fixed!!!! bug CSCwd56032 We pay a service, and it must run well. With no bugs, or anything like that, and it should be fixed by the developers, not by the costumer. SOLUTIONS, no Problems. 

is the problem already fixed?

This bug gives a poor explanation of the affected configurations on Touch 10.This should mention that this only applies to 'remote' pairing of touch 10 navigators? Why would this affect direct pairings to codecs/endpoints? The navigator does not have...

Based on the bug check, I should run the ntpq -p -4 command on the controller, but it does not mentioned how to interpret the output of the command. I have attached the screenshot could someone advise how do I interpret?    

Dear all, are there any news on this bug? Is it fixed in latest releases?In my case, with 8.5.151.0 on 2800 APs with mobility express, I see message log on the master ap, but clients can authenticate on SSID ith 802.1x.