I need to expand my CML vm on esxi 8, which would be #2. However, once you read the steps for "adding 2nd vmdk" they are the exact same for "expanding existing vmdk". What is the difference between the two below? the steps are the same for either. ht...
Forum Posts
Anyone have any success getting CML virtualization to work on an IBM ThinkPad X1. I've tried everything I could find in the posts including enabling in the BIOS, disabling HyperV, disabling core isolation, etc. I continue to get the error "Virtualize...
Resolved! CML reset user admin
HelloUnfortunately, I forgot the password for the administrator account. I can log in with the sysadmin user. I looked in the documentation, but I never found any procedure for resetting the password. Does anyone know if there is a procedure to reset...
Hi Community,i have a problem with a new CML 2.6.1 installation with LDAP authentication. The Authentication via LDAP is working with/without NTLM and users/admins can login to CML. The problem is: The users/admins are not displayed in the User Datab...
Steps followed to Install Trex: Connect TREX eth0 interface to external connector.Set External Connector in bridge config modeEth0 port is mgmt.Connect TREX eth1 interface to another router/switch, In eth1 we want to send trafficGive the below config...
Hello, I'd like to know if you guys can help us, i find very hard to book a lab on CML, every time i try it says the maximum is reached. I'd like to ask you if you can allow us to reserve even if the maximum is reached so that we can be notified as s...
Resolved! Documenting my journey with CML personal
So - I am studying for CCNP. I have to keep my costs down (until I make that big CCNP money, LOL). I had been using devnet sandbox CML for a while. I stopped being able to get reservations on the sandbox some time ago. When I tried to start study...
I am working on setting up a Cisco CML environment on an ESXI host, but during the setup process it does not recognize the ISO. I created the VM using the provided OVA and configured the VM to connect to the ISO file at start up. Is there something I...
The /etc/hosts file is a readonly file. Is there any way I can create another hosts file to add devices to in order to complete an ansible lab?
Resolved! I don't have access to CML
I'm trying to access Cisco Modeling Labs and it says: Environment Launch was denied
I am trying to get my VM up and running and I am encountering an error Virtualized Intel VT-x/EPT is not supported on this platform. Continue without virtualized Intel VT-x/EPT? Hyper V is disabled (see attached)Core isolation is off Any ideas wha...
Ignore polish language. I am trying to find video about this lab.
Why can't I ping the devices in Cisco Devnet lab from my ubuntu running on a VM ? I can access the Devnet CML via https from the VM,I can't ping the IP though,which is weird.I am connected via VPN ofc to the Devnet CML lab. I can see the routes -CML...
Resolved! IOSv Switchport Config Support
Hi All,Trying the following config on a wiped IOSv router: interface GigabitEthernet0/0 switchport trunk encapsulation dot1q switchport mode trunk switchport trunk allowed vlan 10,20but appears no support for "switchport" command as I get:insertho...
I want to test multicast sending and receiving on my CML2 network. What are the best tools to do this? Maybe Trex, VLC, Mpings from a host, etc? Maybe the Alpine as a receiver but how would i confirm, perhaps NIC stats? Thanks for your help!
