cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
255
Views
5
Helpful
1
Replies

Agent State Changes to Not Ready After Failover

Badar Ali
Beginner
Beginner

Hi,

We are facing this problem in our CTI Application that if the agent was in Ready state, after the failover has happened the agent state is changed to Not Ready - Connection Failure. In our CTI, we are using CAXL for the XMPP connection.

However, if we perform the same scenario on Finesse, it maintains its state of Ready. We have tested this on UCCE 12.6 and UCCE 12.0.

1 Accepted Solution

Accepted Solutions

dhiarumu
Cisco Employee
Cisco Employee

Hi,

Finesse desktop failover saves the agent state before failover and retains the Ready or even pending Not Ready/Ready/Wrap-up states after the failover, by sending the respective state change requests after failover automatically. This has to be explicitly taken care by the clients.

Regards

Dhina

View solution in original post

1 Reply 1

dhiarumu
Cisco Employee
Cisco Employee

Hi,

Finesse desktop failover saves the agent state before failover and retains the Ready or even pending Not Ready/Ready/Wrap-up states after the failover, by sending the respective state change requests after failover automatically. This has to be explicitly taken care by the clients.

Regards

Dhina

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community:

Recognize Your Peers