01-20-2012 08:39 AM - edited 03-14-2019 09:13 AM
Hello Everybody,
I would like to know how can I change the refresh rate in CSD, because my refresh rate of CSD is set up to manual, but I would like to change it to auto refresh.
I attached a image about it.
Thanks.
01-20-2012 09:30 AM
Eric,
If it is grayed out that most likely means the filed's refresh cannot be changed, the following guide shows which ones can and which ones cannot:
HTH,
Chris
01-20-2012 09:35 AM
Eric, found an older forum that covered this. Suggested to uninstall/reinstall as well as remove and rebuild the supervisor. Ultimately looks like they opened a TAC case, but no notes what came of it. May want to reach out to original poster to see what came of the TAC case.
https://supportforums.cisco.com/message/3335416#3335416
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide