ā02-06-2010 03:16 PM - edited ā03-14-2019 05:14 AM
After smooth with wizard create application on ccx 5.0(2) everything was going well except thing that I can have only one call at queue. For next call I get busy signal until call in queue was terminate or answered.
Solved! Go to Solution.
ā02-06-2010 03:23 PM
You need a bigger port pool (group). I haven't played with UCCX for a while, but with IPIVR you had to configure both the number of ports and the size of the Media Control Group.
Check your settings.
Maybe you have one configured to match the number of ports you want - probably up to your licence - (corresponding to the number of concurrent calls in the IVR getting treatment or in queue) but not the other. Easy mistake to make back then.
Regards,
Geoff
ā02-06-2010 03:23 PM
You need a bigger port pool (group). I haven't played with UCCX for a while, but with IPIVR you had to configure both the number of ports and the size of the Media Control Group.
Check your settings.
Maybe you have one configured to match the number of ports you want - probably up to your licence - (corresponding to the number of concurrent calls in the IVR getting treatment or in queue) but not the other. Easy mistake to make back then.
Regards,
Geoff
ā02-06-2010 10:37 PM
Are you sending the call to skill group or a queue? Some times people get confused and they send calls to skills and if you don't have more than one agent logged in ready calls may fail. Just another idea if you have already check the ports and limits.
Good luck,
Baseer.
ā02-07-2010 12:05 PM
Check you have enough CTI ports. Also check the settings in your application you can limit the amount of concurrent calls in there also.
/Jon
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide