05-13-2019 06:02 AM
Hi,
is there any way to play a beep after the prompt is played to enter digits using the "get digit string" step in UCCX? This is a configurable parameter using the "record" step, but not the "get digit string" step.
Is there any system prompt that can be used (as in : concatenate the custom "digit collecting" prompt with a system beep prompt, or is it required to embed the beep in the prompt referenced by the "get digit string" step (would be very cumbersome)
Kind regards,
Juan
05-13-2019 08:06 AM
05-13-2019 10:10 AM - edited 05-13-2019 10:11 AM
Hi there
As Mike correcly pointed, all you need is just to add the beep prompt into the Get Digit String.
Hope this Helps
Cheers
Rath!
***Please rate helpful posts***
05-13-2019 11:11 PM
Thx Rath and Mike - but I was kinda looking for a built-in beep, not having to rely on an external prompt.
The start tone is not available for the get digit string step - only for the recording step - hence my question as I use the get digit string step.
Kind regards,
Juan
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide