03-11-2013 04:19 AM - edited 03-14-2019 11:23 AM
I will be performing new ucce setup on new UCS B series chasis.
Havent have complete idea like where to start & what all config need to be done on UCS but known on ucs terminology.
can someone through lights on config parameter to start config steps to start with new UCS installation ,followed by any other inputs appreciated.
UCS H/w : UCSB-B200-M3-U
Component mapping Requirement: Each Esxi will carry 6 nodes on it.
How much time requires to setup fresh install of 14 ucs boxes
Thanks
Manz
03-11-2013 04:35 AM
Hi Manjunath,
Please refer the below links for your current query,
http://docwiki.cisco.com/wiki/Virtualization_for_Unified_CCE
http://docwiki.cisco.com/wiki/Before_You_Buy_or_Deploy_-_Considerations_for_Design_and_Procurement
http://docwiki.cisco.com/wiki/Implementing_Virtualization_Deployments
Hope this helps.
Anand
Please rate helpful posts !!
03-11-2013 04:51 AM
Hi Manjunath,
If you planning for install the UCCE on UCS servers. You can approach either by Tested Refence Configuration or Spec Based.
TRC's and Spec-Based configuration for specific Hardware is given in the below link.
http://docwiki.cisco.com/wiki/UC_Virtualization_Supported_Hardware#B200_M3_TRC.231
Regards,
Senthil.
03-11-2013 05:13 AM
Our h/w suits under B200 M3 TRC#1 based.
Thanks this is informative, however for the post install config iam referring to UCS config guide
Btw, iam wondering how to start acessing UCS , before to that i know we need to assign the IP's to device. Can you please help me where to perform the IP assignement inorder to access UCS
03-11-2013 05:39 AM
Hi Manjunath,
For getting your UCS box configuration helps, I would suggest you post a thread under Unified Computing
Regards,
Senthil
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide