VRUPIM showing configured

[syedmd866]

What is mean by configured, can any one share list of Processes with details.

vrupim.exe : ucce-PG9B vrupim - pim2 - [CVP_2 CONFIGURED] : 26.08:26:33

vrupim.exe : ucce-PG9B vrupim - pim1 - [CVP_1 CONFIGURED] : 26.08:26:33

[senthilnatarajan]

it is in the "configured" state because the PIMs are active on side A.

At a given time, PIM can connect to only 1 PG, either side A or side B.

The state will change from "Configured" to Active, 

1. when your side A PG process shuts/restarts.

2. Also assuming your PG is duplexed

-Senthil

[syedmd866]

Hi Senthil,

Currently Side A it is active, but in side B it should be Idle why it is showing configured.

2. Also assuming your PG is duplexed---- How to check this for my reference.

Thanks,

[senthilnatarajan]

when it comes to PIM, it is normal to show as "configured". Thats what I see in my system.

As for the duplex, you should be able to see that in the pgsetup for Pg and web setup for rogger.

I have attached the screenshot for PG. Also I believe you can check the very same settings in the registry