Adding 35x VGs using BAT: MAC Address

[conor.maton]

Hello all,

I currently have 35x Cisco VG350s racked up in a lap with no configuration enabled. I am looking to prepare adding these to CUCM using the Bulk Adminsitration Tool.

After a quick research I understand I need the MAC address of the VG and preceed this with 'SKIGW' as it will communicate via SCCP. However I am unsure how I find the MAC address of the VG350, or if I need to add any preceeding config. Can anybody help pelase?

Thank you in advance!

[conor.maton]

Anyone? What doesn't help is I'm using Loopback0 which doesn't have a MAC address:

sccp local Loopback0

[Rejohn Cuares]

This does not answer your question but follow this guides to successfully integrate the VG to CUCM.

https://www.cisco.com/c/en/us/support/docs/voice/skinny-call-control-protocol-sccp/211575-CUCM-Auto-Configuration-for-SCCP-Gateway.html

https://community.cisco.com/t5/collaboration-voice-and-video/stcapp-how-to-configure-fxs-ports-on-cucm/ta-p/3142555