09-25-2012 11:38 AM - edited 03-16-2019 01:23 PM
We recently moved our site in the UK to another facility. The prior facility had a dedicated pots line for their fax. At the new facility we chose not to port the pots. Instead assign an extension on ATA. The only device we could get is the newest ATA187. When trying to apply the firmware to the router, it doesn't seem to want to take.
Anybody know if the newer device is not compatible with older versions of CME/CUE? Ours is 3.2
Thanks to everybody in advance.
Solved! Go to Solution.
09-25-2012 11:42 AM
Hello Ross,
The ATA 187 is not compatible with CME 3.2, take a look on CME 3.2 Compatibility matrix, only ATA 186 and 188 are compatible with this CME version!
http://www.cisco.com/en/US/docs/voice_ip_comm/cucme/requirements/guide/cme32spc.htm
ATA 187 is compatible with CME 9.0
http://www.cisco.com/en/US/docs/voice_ip_comm/cucme/requirements/guide/cme90spc.html
Rate this if helps!
Regards
Leonardo Santana
09-25-2012 11:42 AM
Hello Ross,
The ATA 187 is not compatible with CME 3.2, take a look on CME 3.2 Compatibility matrix, only ATA 186 and 188 are compatible with this CME version!
http://www.cisco.com/en/US/docs/voice_ip_comm/cucme/requirements/guide/cme32spc.htm
ATA 187 is compatible with CME 9.0
http://www.cisco.com/en/US/docs/voice_ip_comm/cucme/requirements/guide/cme90spc.html
Rate this if helps!
Regards
Leonardo Santana
09-25-2012 11:46 AM
Aye yi yi. Ok, no prob. Thank you sir.
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: