cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Announcements
1081
Views
5
Helpful
2
Replies
Highlighted
Beginner

Call duration limitation

Hi experts,

We faced a problem that some user don't hang up the call so there will have some ports be always occupied...

Is there any possibility to limit call duration on ISR 4431 or 3945?

Like if call duration exceed 1 hour, ISR will initiatively disconnect the call..

 

thanks in advance

1 ACCEPTED SOLUTION

Accepted Solutions
Highlighted
Collaborator

Hi

Service parameter configuration can help you achieving this. But its a global configuration and affects all calls, both internal and external.

 

This parameter specifies the minutes that a call can remain active before Cisco CallManager clears it. A value of zero disables the timer.
  This is a required field.
  Default:  720
  Minimum:  0
  Maximum:  35791
  Unit: min

 

You need to write down a TCL script. Please check out a similar post

https://supportforums.cisco.com/t5/ip-telephony/how-to-set-timer-to-force-disconnected-outgoing-incoming-call/td-p/1352838

 

 

 

 

Cheers
Rath!


***Please rate helpful posts***

 

View solution in original post

2 REPLIES 2
Highlighted
Cisco Employee

Nothing native on the IOS. You can use a TCL script. Open up a TAC case and see if they can provide you one. It is a generic template script that should work fine but is not TAC supported. Alternatively you can post at Cisco Developer Forums. Someone there should be able to help you.

Nipun Singh Raghav
"We cannot solve our problems with the same thinking we used when we created them"
Highlighted
Collaborator

Hi

Service parameter configuration can help you achieving this. But its a global configuration and affects all calls, both internal and external.

 

This parameter specifies the minutes that a call can remain active before Cisco CallManager clears it. A value of zero disables the timer.
  This is a required field.
  Default:  720
  Minimum:  0
  Maximum:  35791
  Unit: min

 

You need to write down a TCL script. Please check out a similar post

https://supportforums.cisco.com/t5/ip-telephony/how-to-set-timer-to-force-disconnected-outgoing-incoming-call/td-p/1352838

 

 

 

 

Cheers
Rath!


***Please rate helpful posts***

 

View solution in original post

Content for Community-Ad