call routing

[elite2010]

Hi,

I have the following conditions.

• Have sip trunk which is connected to remote non cisco pbx
• And route group with two mgcp gateway on premise .

I need to achieve the following .

• If the user calls calls must  go through  sip trunk . If sip trunk fails  need to use the second option

Thanks

[HARIS_HUSSAIN]

You can create Route Group say RG_SIP in which you put the SIP Trunk to PBX, Create another Route Group with Two local MGCP GW. Create Route List and Put RG_SIP and MGCP Route Group. Use this in Route Patterns

*** Please rate helpful post; Mark "Accept as a Solution" if applicable

Thanks,
Haris

[Jaime Valencia]

https://www.cisco.com/c/en/us/td/docs/voice_ip_comm/cucm/srnd/collab12/collab12/dialplan.html#pgfId-1135999

[Dennis Mink]

Make sure you use OOB options 'ping' on your sip trunk in cucm, so that if it goes out of service, it can successfully fail over to your mgcp gateway