03-23-2019 10:27 PM
Hi,
I have the following conditions.
I need to achieve the following .
Thanks
03-23-2019 11:12 PM - edited 03-23-2019 11:17 PM
You can create Route Group say RG_SIP in which you put the SIP Trunk to PBX, Create another Route Group with Two local MGCP GW. Create Route List and Put RG_SIP and MGCP Route Group. Use this in Route Patterns
*** Please rate helpful post; Mark "Accept as a Solution" if applicable
Thanks,
Haris
03-24-2019 05:13 PM
03-24-2019 06:27 PM
Make sure you use OOB options 'ping' on your sip trunk in cucm, so that if it goes out of service, it can successfully fail over to your mgcp gateway
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide