cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
3099
Views
0
Helpful
2
Replies

Calling ID is Unknown Number - Incoming Calls

ahmad_tamneh
Level 4
Level 4

Dears,

I have MGCP gateway, it has Vic2-4FXO , one FXO ports has analog line that is connected to Telular, the Incoming calls to an IP phone through this port shows Unknown Number for the Calling ID, I tried to change the related service parameters related to the calling ID, with no luck.

The debug voice ccapi in out at the gateway shows that the calling ID received , but when call arrives the IP phone the calling ID shows as unknown number

Any Idea

1 Accepted Solution

Accepted Solutions

paolo bevilacqua
Hall of Fame
Hall of Fame

MGCP does not suppoer caller ID.

Use instead, H.323, or SIP.

View solution in original post

2 Replies 2

paolo bevilacqua
Hall of Fame
Hall of Fame

MGCP does not suppoer caller ID.

Use instead, H.323, or SIP.

http://www.cisco.com/en/US/products/sw/voicesw/ps556/products_tech_note09186a008009428e.shtml

Caller ID does not work on FXO ports. This is because caller ID is not supported with FXO ports when configured for MGCP. Instead, configure the gateway in H.323 mode

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: