Calling number not displayed

[Youssef BETTAR]

Hi

We have a H323 gateway and a CUCM 9.1.2 version, when we receive a call from our E1 line we can see the calling number on the gateway but the calling number is unknown on th phone

[Ayodeji Okanlawon]

Can you share your debug isdn q931..(include calling and called number)

What phone model are you using? Has this worked before or is this a new deployment?

Can you also attach your sh run here

[Youssef BETTAR]

thank you for your reply.

we have a 7965 whith SCCP45.9-4-2-1S firmware

you can find in attachement the sh run and the debug

[Ayodeji Okanlawon]

Youssef,

Is this your full configuration. I don't see any dial-peers on your gateway. How is the call sent to cucm?

[Youssef BETTAR]

Hi

Sorry

dial-peer voice 1123 voip
 destination-pattern 877....
 progress_ind alert enable 8
 progress_ind progress enable 8
 session target ipv4:10.x.x.x
 dtmf-relay h245-alphanumeric
 ip qos dscp cs3 signaling
 no vad

[Ayodeji Okanlawon]

OK..please do another test call and send the ff:

debug voip ccapi inout

debug isdn q931

NB: its important to provide detailed information so we can help as quickly as possible..

[Youssef BETTAR]

ok

[Carlo Poggiarelli]

Hi Youssef.

On your config do you have an incoming diapeer with incoming calling-number command?

Let us know

Regards 

Carlo

[Youssef BETTAR]

Hi Carlo 

i have already tested that by adding a incoming calling-number . command but i have the same issue and i have removed it after

[Carlo Poggiarelli]

Hi.

Can you please send us a full config of your gateway?

A screenshot of H323 gateway configuration page on CUCM would be useful.

Thanks

Regards

Carlo

[Youssef BETTAR]

ok thanks

[Carlo Poggiarelli]

Hi Youssef

Try this:

dial-peer voice 10 pots

incoming called-number 877T

port 0/0/0:15

direct-inward-dial

Let us now

Regards

Carlo