08-24-2011 05:19 PM - edited 03-16-2019 06:40 AM
Dear All
Does any one know about 2N GSM gateway integration with CUCM 8X? What I am looking for is the integration using FXO /FXS / VG224 port.
GSM gateway used by Customer which currently connects to Siemens PBX using RJ11: http://www.2n.cz/en/products/gsm-gateways/analog/easygate/
I have found that there is another GSM gateway from the same company that can be connected to CUCM as a SIP device (http://www.2n.cz/en/products/gsm-gateways/voip/voiceblue-next/) But I am looking for a way to connect the existing
2N® EasyGate analog GSM gateway to CUCM using FXS/FXO/VG224 port.
Many Thanks
Joseph J
Solved! Go to Solution.
08-25-2011 02:20 AM
Hi Joseph
Looking at the box you quoted the interface is :-
This means you will need to use an FXO (2 wire) on the Cisco CUCM side.
I have seen many similar setups in th UK called MOBEX
You will need to create a gateway H323/MGCP where the FXO resides.
You will need to know the access codes/routes and what digits to send to the easygate.
HTH
Alex
08-25-2011 02:20 AM
Hi Joseph
Looking at the box you quoted the interface is :-
This means you will need to use an FXO (2 wire) on the Cisco CUCM side.
I have seen many similar setups in th UK called MOBEX
You will need to create a gateway H323/MGCP where the FXO resides.
You will need to know the access codes/routes and what digits to send to the easygate.
HTH
Alex
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: