I'm trying to reset roughly a few dozen T1's.....This might take a while, is there a range command that I can use similar to the int range command for interfaces?
You need to individually enter into controller port and do the shut/no shut or if T1s are coming from a single card of MUX of SP, then, that card could be reset.
You need to individually enter into controller port and do the shut/no shut or if T1s are coming from a single card of MUX of SP, then, that card could be reset.
regds,
aman
Getting Started
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: