Michael Ricci
Level 1
Level 1
Member since ‎11-03-2010

User Statistics

  • 62 Posts
  • 0 Solutions
  • 16 Helpful votes Given
  • 0 Helpful votes Received
Recent Badges
10 Replies
5 Replies
20 Replies

User Activity

I'm trying to reset roughly a few dozen T1's.....This might take a while, is there a range command that I can use similar to the int range command for interfaces?
I was having issues with Cisco Anyconnect 3.0.07059, so I uninstalled it and and tried installing version 3.1.02040, but whenever I do, I get this error (see attached file). Many people in my office have had issues installing anyconnect as well, it s...
I currently have the following setup. I have an 800 number that sends all calls to CVP, which is acting as an auto-attendant. When the user presses "0", the call is sent to a hunt pilot I configured. Phone 1 - 8260001Phone 2 - 8260002 Phone 3 - 82600...
Say I have 3 Phones 1001 - Display "HQ1 VoIP Engineer"1002 - Display "HQ1 Network Engineer"2000 - Display "HQ2 VoIP Engineer"Let's say 1001 calls 1002, the phone number and display is correct on 1002. 1002 (HQ1 Network Engineer) decides that the HQ2 ...
I am trying to add firmware to a 2811 with an IOS of 12.4(13r)T11. I uploaded all the firmware files, but when I enter telephony-service, and type "load" and the model type (7945), I get an error. When I execute a "load ?", I only show the phone mode...
Community Statistics
Member Since ‎11-03-2010 04:48 AM
Date Last Visited ‎11-08-2019 12:03 AM
Posts 62