Hello all....I'm having trouble connecting a 3CX SIP softphone (Windows) to my CME router- version 8.6. Router is 2851 ISR- all connected via a lan switch in my office. Connectivity is fine between the PC\softphone and the router.
I have successfully setup 3 SCCP phones (all Cisco) but I'm not too clear why the SIP softphone is having issues- I've Google and read quite a bit but maybe somebody can check my config-- I'm sure I'm missing something. Also, tried to get some debug info from various debug ccsip xxx commands, but the console is overwhelmed with lines of debug- nothing that stands out anyway. I am familiar configuring sip phones for Asterisk....as I have a working PBX up here...but not so much for CME\Cisco.
Here's my pertinent config sections--- like I mentioned, I have working skinny phones on the same CME system. I wouldn't need to specify phone loads and type and tftp paths for a simple sip softphone would I??? Thanks in advance....Dennis
voice service voip
allow-connections sip to sip
sip
!
!
voice register global
mode cme
source-address 192.168.0.254 port 5060
max-dn 5
max-pool 5
authenticate register
!
voice register dn 1
number 1041
name DenOffice3CX
label DenOffice3CX
!
voice register pool 1
id mac 94DE.802D.8921
number 1 dn 1
username 1041 password cisco
codec g711ulaw
