cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Announcements
323
Views
10
Helpful
2
Replies
yelankoud1
Beginner

Cannot Create Custom Phone Button template for ATA 191 CUCM

Hello Everybody,

I have just installed CUCM 12.5 (Publisher/Subscriber), and I have 10 Cisco ATA 191 (1 RJ45 Port, 2 RJ11 port)

I want to register them on CUCM, I found it's default Phone Button Template has 1 Line, I tried to create Custom Phone Button Template for these ATA 191 that's support 2 Lines, but it's not possible to create the Second Line for it?

I tried to connect them by WebUI, it's Web Interface displays nothing to Modify

 

Could you please help me for this

Thank you in advance

1 ACCEPTED SOLUTION

Accepted Solutions
Nithin Eluvathingal
VIP Advisor

 To add second line you need to register it as a second device changing the mac . The phone 2 MAC address need to be fabricated as mentioned below. 

 

Example

If the MAC address of the Cisco ATA is 00070EA26032, then the fabricated MAC address for the Phone 2 port would be 070EA2603201.

 

 



Response Signature


View solution in original post

2 REPLIES 2
Nithin Eluvathingal
VIP Advisor

 To add second line you need to register it as a second device changing the mac . The phone 2 MAC address need to be fabricated as mentioned below. 

 

Example

If the MAC address of the Cisco ATA is 00070EA26032, then the fabricated MAC address for the Phone 2 port would be 070EA2603201.

 

 



Response Signature


View solution in original post

Thank you Nithin,

it's worked perfectly

Thank you again

 

Create
Recognize Your Peers
Content for Community-Ad