12-25-2016 10:53 PM - edited 03-17-2019 09:02 AM
Dear Cisco Team and All,
I am confused because each telephone line is working fine on single direct telephone.but i am installing 4-Four lines on VIC card but unfortunately its not working, so after that all line is not working...i am getting ringing tone just...
Solved! Go to Solution.
12-26-2016 06:20 AM
Hi,
Can you please share the config for this FXO and the show inventory?
what protocol you are using for this FXO, MGCP, SIP, H.323?
What is the IOS version and the platform you are using?
So, seems that you have a 4 port FXO card, and you are connecting 4 POTS lines, for incoming and outgoing calls from your IP Phones, correct?
Also, you say that these are not working, and seems you are getting a ringing tone, is that for outside calls? And what happens after you get the ringing tone?
Regards,
Christian.
12-26-2016 06:20 AM
Hi,
Can you please share the config for this FXO and the show inventory?
what protocol you are using for this FXO, MGCP, SIP, H.323?
What is the IOS version and the platform you are using?
So, seems that you have a 4 port FXO card, and you are connecting 4 POTS lines, for incoming and outgoing calls from your IP Phones, correct?
Also, you say that these are not working, and seems you are getting a ringing tone, is that for outside calls? And what happens after you get the ringing tone?
Regards,
Christian.
12-26-2016 09:31 PM
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide