04-26-2021 09:42 AM
Hi Guys,
Im trying to put PLAR working on a Cisco 8851 (SIP Phones) and its nor working. With SCCP phones it works, but with SIP is not.
This is the steps that i made:
Create a partition
Create a CSS and put the Partition inside
Create a blank translation in the new partition that i create, transforming to the destination
then i create a Sip Dial rule 7940_7960_OTHER with Button dial 1
Then i put the CSS created in the phone that is being used to make the call automaticly, and put the Dial Rule to.
I do all this steps but its not working for SIP devices only SCCP. Can anyone can help on this?
Best Regards,
Hugo Sousa
Solved! Go to Solution.
04-28-2021 05:11 AM
Hi All,
Its already working. In my case i need to put the Sip Dial rule with a Pattern with a blank field.
Best Regards,
Hugo Sousa
04-26-2021 10:13 AM
See this document for details on how to configure PLAR on SIP phones. https://www.cisco.com/c/en/us/support/docs/unified-communications/unified-communications-manager-callmanager/212073-CUCM-PLAR-Configuration-Example.html#anc6
04-26-2021 10:37 AM
Refer the Guide Roger mentioned.
04-27-2021 07:10 AM
Hi Roger,
I try that configuration and this is not working.
Best Regards,
Hugo Sousa
04-27-2021 09:24 AM - edited 04-27-2021 09:25 AM
I Followed the same for a customer few years back and it worked perfect for me. Read carefully and configure all mentioned configurations in the document.
I can share the screenshot of working configuration tomorrow.
04-28-2021 05:11 AM
Hi All,
Its already working. In my case i need to put the Sip Dial rule with a Pattern with a blank field.
Best Regards,
Hugo Sousa
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide