CME with SIP Trunk and Cisco Unity Express

[danm]

I have a Cisco 3745 running 12.4(11)XJ2 / CME 4.1 / CUE with our PSTN access through a SIP Trunk. Everything is working ok except access to Cisco Unity Express, when it gets transferred to VM the caller hears fast busy tone.

Any Ideas? Thanks in advance.

Dan

[paolo bevilacqua]

Hi,

Are the calls coming in with G.711? Nothing else would work with CME.

Does it fails only when transferred, or also when calling main VM number directly ? If the first, you may need to configure:

voice service voip

allow-connections sip to sip

no supplementary-service sip moved-temporarily

To confirm collect output of "debug ccsip message" with "term mon" to know a little more.

Hope this helps, please rate post if it does!

[spazziani]

Hi Damm,

Did you solve your problem, because I'm having the same problem. Could you help me please ?

Regards,

Vinicius

[Arun Thomas]

Please check the dial-peer configs. Sample configs below.

dial-peer voice 200 voip

description CUE-Voicemail

destination-pattern 8000

b2bua

session protocol sipv2

session target ipv4:1.1.1.1

dtmf-relay sip-notify

codec g711ulaw

no vad

[spazziani]

Arun Thomas,

I verified the dial-peer and it doesn't have two commands "dtfm-relay sip-notify" and "no vad". After I put both commands solved my problem.

Thank you very much.

Vinicius

[Arun Thomas]

Happy to see that your issue is resolved. but i dont think that its the dtmf command but may be the "no vad"

Please rate post if it does!

[some]

Can you post a sample config for your setup?  It would really help me right now.  You can cure the output