cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Announcements

Community Helping Community

192
Views
15
Helpful
4
Replies
Highlighted

collaboration

what is the use of sip profile in sip trunk configuration?

Everyone's tags (1)
1 ACCEPTED SOLUTION

Accepted Solutions

Re: collaboration

The "sip profile" describes all the sip settings of the sip trunk, for example early-offer, T38, ANAT. Moreover, through this profile you can setup the settings to monitor the sip trunk and check via CUCM admin page if the sip-trunk is up and running.

You may check the following post: https://www.cisco.com/c/en/us/td/docs/voice_ip_comm/cucm/admin/9_0_1/ccmcfg/CUCM_BK_CDF59AFB_00_admin-guide-90/CUCM_BK_CDF59AFB_00_admin-guide_chapter_01001110.pdf

George

 

Please Rate Posts (by clicking on Star) and/or Mark Solutions as Accepted, when applies

View solution in original post

4 REPLIES 4

Re: collaboration

The "sip profile" describes all the sip settings of the sip trunk, for example early-offer, T38, ANAT. Moreover, through this profile you can setup the settings to monitor the sip trunk and check via CUCM admin page if the sip-trunk is up and running.

You may check the following post: https://www.cisco.com/c/en/us/td/docs/voice_ip_comm/cucm/admin/9_0_1/ccmcfg/CUCM_BK_CDF59AFB_00_admin-guide-90/CUCM_BK_CDF59AFB_00_admin-guide_chapter_01001110.pdf

George

 

Please Rate Posts (by clicking on Star) and/or Mark Solutions as Accepted, when applies

View solution in original post

Re: collaboration

thank q  geroge for your support i have one more doubt that is

what is the use of the following parameters

1. accept out of dialog refer

2. accept unsolicited notification

3. accept replace header

Everyone's tags (1)

Re: collaboration

The following parameters are the messages that the SIP trunk is able to accept (upon your check). I would strongly suggest you to read the following. to gain some better understanding:

Cisco Live Session "SIP Trunk design and deployment in Enterprise UC networks: https://www.ciscolive.com/c/dam/r/ciscolive/apjc/docs/2018/pdf/BRKUCC-2006.pdf

From Cisco Documentation:https://www.cisco.com/c/en/us/td/docs/voice_ip_comm/cucm/security/9_1_1/secugd/CUCM_BK_C0395F44_00_cucm-security-guide-91/CUCM_BK_C0395F44_00_cucm-security-guide-91_chapter_011001.htmlODR.PNGand/or the post from Community

 

https://community.cisco.com/t5/collaboration-voice-and-video/cucm-sip-trunk-tls-configuration-and-troubleshooting/ta-p/3114705#toc-hId-1272369412

I hope these help,

George

 

 

 

Please Rate Posts (by clicking on Star) and/or Mark Solutions as Accepted, when applies
Hall of Fame Master

Re: collaboration

+5 for George for great explanation.  In summary it's another template of settings that may be common across many SIP trunks that rather than defining them on each SIP trunk individually CUCM allows you to do it at the profile level, and then apply the profile to any SIP trunk.

CreatePlease to create content
Content for Community-Ad
FusionCharts will render here