05-12-2011 11:06 AM - edited 03-16-2019 04:56 AM
There is a CUCM with 4 branch routers on SRST mode, all remote routers have enough resources locally, so I wish to used them, so I configured conferencing and transcoding as the following link:
http://www.cisco.com/en/US/docs/ios/12_3/vvf_c/interop/intcnf2.html#wp1087839
But, when I try configuring on CUCM the Media Resources profiles, the dsp profiles are not associated, I get the message "ASSOCIATION IN PROGRESS", can someone give some ideas how should I configure CUCM media resources for branch routers??
Thanks,
Juan Carlos Arias
Solved! Go to Solution.
05-12-2011 11:28 AM
Hi Juan Carlos,
A few things that come to mind
-- Can you do the following
sccp
no sccp
-- Make sure you put the version of the callmanager in the 'sccp ccm' command
-- Make sure that the skinny traffic reaches callmanager
You can use a sniffer in callmanager or some sccp debug commands on the gateway
ie debug sccp packets
debug sccp events
-- Did you configure the relevant resourced in callmanager ?
Hope the above will help
Christos
05-12-2011 11:28 AM
Hi Juan Carlos,
A few things that come to mind
-- Can you do the following
sccp
no sccp
-- Make sure you put the version of the callmanager in the 'sccp ccm' command
-- Make sure that the skinny traffic reaches callmanager
You can use a sniffer in callmanager or some sccp debug commands on the gateway
ie debug sccp packets
debug sccp events
-- Did you configure the relevant resourced in callmanager ?
Hope the above will help
Christos
05-12-2011 12:23 PM
Thanks Christos for your comments about it, when I was reading to your comments, I was thinking reviewing again the configuration, and I notice that CUCM IP address was incorrect!! Sorry for that, but you help me refreshing my ideas. Now they are associated.
Regards,
Juan Carlos Arias
05-13-2011 12:25 AM
Hey Juan Carlos,
It was easier than I expected
Thanks for posting out the solution !
Christos
05-13-2011 07:54 AM
I noticed of that when I enebled the debug.
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide