Configuring Media Resources on CUCM

[Juan Carlos Arias Perez]

There is a CUCM with 4 branch routers on SRST mode, all remote routers have enough resources locally, so I wish to used them, so I configured conferencing and transcoding as the following link:

http://www.cisco.com/en/US/docs/ios/12_3/vvf_c/interop/intcnf2.html#wp1087839

But, when I try configuring on CUCM the Media Resources profiles, the dsp profiles are not associated, I get the message "ASSOCIATION IN PROGRESS", can someone give some ideas how should I configure CUCM media resources for branch routers??

Thanks,

Juan Carlos Arias

[Christos Georgiadis · Accepted solution]

Hi Juan Carlos,

A few things that come to mind

-- Can you do the following

sccp

no sccp

-- Make sure you put the version of the callmanager in the 'sccp ccm'  command

-- Make sure that the skinny traffic reaches callmanager

You can use a sniffer in callmanager or some sccp debug commands on the gateway

ie debug sccp packets

debug sccp events

-- Did you configure the relevant resourced in callmanager ?

Hope the above will help

Christos

[Juan Carlos Arias Perez]

Thanks Christos for your comments about it, when I was reading to your comments, I was thinking reviewing again the configuration, and I notice that CUCM IP address was incorrect!!   Sorry for that, but you help me refreshing my ideas.  Now they are associated.

Regards,

Juan Carlos Arias

[Christos Georgiadis]

Hey Juan Carlos,

It was easier than I expected

Thanks for posting out the solution !

Christos

[Juan Carlos Arias Perez]

I noticed of that when I enebled the debug.